How to Sharpen Ski Edges at Home

Sharp edges grip ice and hard groomers. Here's how to sharpen them with a guide and diamond stones without wrecking the bevel.

What you need

Step by step

  1. Check the edges. Run a fingernail along them. Burrs catch your nail. Rock hits leave hardened spots that a file skates over. Knock those down with a coarse stone first.
  2. Mark the edge. Run a marker along the side edge. After a few passes, the ink shows exactly where you're removing steel and confirms the guide is sitting flat.
  3. Deburr the base edge. One or two light passes with a fine stone in a base guide. Don't sharpen the base edge.
  4. Sharpen the side edge. Wet the stone, set it in the guide and work tip to tail in long, overlapping strokes. Go coarse to fine: 200, then 400, then 600 grit. Give each edge the same number of passes.
  5. Deburr. One light pass with a gummy stone along the base and side edge.
  6. Detune if you need to. Dull the tip and tail past the contact points if your skis hook. Racers skip this.

How often

A quick polish with a fine stone every few ski days keeps edges consistent. Do a full sharpen after rock hits, or when your skis start sliding out on firm snow. On icy, eastern or man-made snow, sharpen more often.

Mistakes to avoid

Files, diamond stones and ceramic stones

A file removes steel quickly. Use it only to set a new angle or repair real damage, because every file pass shortens the life of the edge. Diamond stones are what you'll use most: 100 or 200 grit to remove small burrs and nicks, then 400 and 600 to polish. A ceramic or hard stone handles case-hardened spots that a file skates over. Wet diamond stones with water or alcohol so they cut cleanly and don't clog.

Rust and rock damage

Light surface rust comes off with a few passes of a fine stone. To prevent it, dry the edges after skiing and store skis somewhere dry; a summer storage coat of wax helps too. A rock hit leaves a hardened, raised spot. Knock it down with a coarse stone before you sharpen, or the guide will rock over it and round the edge.

How to tell an edge is sharp

Drag a fingernail gently across the edge at a few points along its length. A sharp edge shaves a tiny bit of nail; a dull one slides off. Look along the edge under a light: a sharp edge doesn't reflect light from its corner, while dull spots show as a bright line.

A home routine that works

  1. Before most ski days: a few polishing passes with a 400 or 600 grit stone in the side guide, then a gummy stone to deburr.
  2. Every few days, or after rock hits: the full sequence from coarse to fine.
  3. Once a season: a shop stone grind to flatten the base and reset the base bevel.
Get today's wax for your mountain

Wax color and iron temperature from the forecast for today, tomorrow or this weekend, plus edge settings for how you ski.

Keep reading